Chrome Slatwall Display Hooks Lot of 1000

Description

LIMITED TIME OFFER. SUPPLIES LIMITED.
pay for using BUYNOW & get 10 pieces FREE!
these are
commonly
called
slatwall hooks of
1/4 inch steel rod
the
HOOK RODS ARE
CHROMED
, not zinc plated/anodized. Only the backing plate is zinced.
the actual diameter is 15/64 which is 1/64 less than 1/4
the industry commonly rounds up to the nearest 16th
the diameter mic's out at .236
a true quarter inch would mic out at .250
anyone who tells you otherwise should be ready to mic out their hook with a digital mic in your presence
the production process
the reason for the discrepancy is that the rods are prepared from RAW steel at 1/4 inch, standard stock
the rod is then made smooth through a process that removes some diameter
the rods are then cut, bent, welded and dipped for chrome plating
there are 2 styles of WELDS
hand arc/torch weld which applies a bead between the plate and rod to the left and right on the face (ugly)
spot mechanical weld in an automation process like automobile hoods, fenders, doors etc are done
this type of weld is calculated, uniform, and consistent - also way more attractive (cant see it without inspection. see pic)
OUR SLAT WALL HOOKS USE SPOT WELDS.
CRITICAL MEASURES!
the slat boards themselves should be 1/4" thick (distance between backside of hook drop plate and face of tang is 1/2 inch)
the gap between the top slat board and the bottom one should be 1/4 inch to 3/8 inch (free and clear tang height is 9/16 or 1/2+1/16)
the I.D. of the hole in the tang is 7/32 inch diameter
the plate is 1/16 inch thick
the hook support drop is just over 2 1/2 inches
WEIGHT
A box can weigh up 20 pounds depending on the piece count. That calculation is about 2 pounds per 10 pieces.  Make sure that the person moving this has a good back and exercises proper posturing when picking up or setting down.